西韩城际铁路湿陷性黄土地层现场浸水试验研究

在分析西韩城际铁路沿线黄土分布特征的基础上,选取代表性场地开展现场试坑浸水试验。试验结果表明:场地实测最大自重湿陷量为46 mm,仅为室内压缩试验计算值的0.23倍;湿陷土层厚度15 m,除Q;黄土全部具有湿陷性外,Q;上部黄土亦具有湿陷性;地表水自然入渗深度超过50 m,浸润角约为40°,浸润范围约为浸水试坑直径的1.7倍。对现场实测值和室内计算值差异原因进行深入分析,得出在黄土结构未完全破坏之前,发生过湿陷的土体在特定条件下还有可能再次湿陷的结论。     

基于未确知测度理论的隧道施工瓦斯灾害风险评价

选取煤层厚度、煤层瓦斯含量、回风流平均瓦斯浓度、相对瓦斯涌出量、岩石类型、连通封闭性、深度值、隧道跨度、隧道长度、通风风速和涌水量等11项瓦斯灾害指标作为隧道施工瓦斯灾害风险评价指标体系,并建立各指标的等级标准。将序关系分析法(G1)和反熵权法(AEW)运用拉格朗日乘子法确定组合权重,构建各指标的单指标测度函数,并计算出各指标的综合测度评价向量。为了优化未确知测度置信度识别准则,引进集对分析(SPA)关联系数确定各隧道的瓦斯灾害风险等级。并对24个瓦斯隧道进行瓦斯灾害评价,并和FDA法评价结果和现场实测结果进行对比,精度达到91.7%,基本符合实际情况,表明了该评价方法合理有效,可为隧道施工瓦斯灾害评价提供理论参考。     

倒运海水道整治工程斗朗—川槎大桥段实船适航试验

为验证倒运海水道整治工程是否达到整治标准的通航要求,选取斗朗—川槎大桥段作为实船试验河段,采用该航段设计船型500吨级满载船作为试航船,进行实船适航试验。测量试验河段的水深地形、表面流速流向、航标配布和水位,试验船舶沿设计航线进行上下水航行,实时测量试航船舶航行轨迹、对岸航速、舵角、漂角、船舶与河岸之间的安全距离等航行指标及航行状态,并结合通航规范及标准,对整治后航道技术参数的合理性、航标配布的合理性等进行分析评价。结果表明,本试验航段的整治效果达到了整治标准的通航要求。研究成果可为类似工程提供参考。     

双块式轨枕外形质量快速检测系统研制及应用

SK?2型双块式混凝土轨枕是高速铁路无砟轨道结构中的重要预制件,单一生产厂日均产量达到800~1400根,但目前的人工检测方式无法满足双块式轨枕的出厂检验要求。本文提出的双块式轨枕外形质量快速检测系统可满足TB/T 3397—2015《CRTS双块式无砟轨道混凝土轨枕》的出厂检验要求,与双块式轨枕生产线相匹配,大大提高了检测效率,实现了双块式轨枕全参数、自动化、智能化检测。检测数据自动上传至生产管理平台,可对双块式轨枕生产质量进行跟踪管理。     

Experimental field study of floater motion effects on a main bearing in a full-scale spar floating wind turbine

In this paper we present a full-scale experimental field study of the effects of floater motion on a main bearing in a 6 MW turbine on a spar-type floating substructure. Floating wind turbines are necessary to access the full offshore wind power potential, but the characteristics of their operation leave a gap with respect to the rapidly developing empirical knowledge on operation of bottom-fixed turbines. Larger wind turbines are one of the most important contributions to reducing cost of energy, but challenge established drivetrain layouts, component size envelopes and analysis methods. We have used fibre optic strain sensor arrays to measure circumferential strain in the stationary ring in a main bearing. Strain data have been analysed in the time domain and the frequency domain and compared with data on environmental loads, floating turbine motion and turbine operation. The results show that the contribution to fluctuating strain from in-plane bending strain is two orders of magnitude larger than that from membrane strain. The fluctuating in-plane bending strain is the result of cyclic differences between blade bending moments, both in and out of the rotor plane, and is driven by wind loads and turbine rotation. The fluctuating membrane strain appears to be the result of both axial load from thrust, because of the bearing and roller geometry, and radial loads on the rotating bearing ring from total out-of-plane bending moments in the three blades. The membrane strain shows a contribution from slow-varying wind forces and floating turbine pitch motion. However, as the total fluctuating strain is dominated by the intrinsic effects of blade bending moments in these turbines, the relative effect of floater motion is very small. Mostly relevant for the intrinsic membrane strain, sum and difference frequencies appear in the measured responses as the result of nonlinear system behaviour. This is an important result with respect to turbine modelling and simulation, where global structural analyses and local drivetrain analyses are frequently decoupled.     

Short-term statistics of ice loads on ship bow frames in floe ice fields: Full-scale measurements in the Antarctic ocean

Ship operation and ice loading in floe ice fields have received considerable interest during recent years. There have been several numerical simulators developed by different institutes which can simulate ship navigation through floe ice fields and estimate ship performance and local ice loads. However, public data obtained from full-scale measurement covering comprehensively ship performance and ice loads under various ice thicknesses, concentrations and floe sizes are rare. The 2018/19 Antarctic voyage of the Polar Supply and Research Vessel (PSRV) S.A. Agulhas II gathered considerable data of the ship in floe ice fields under various thicknesses, concentrations, and floe sizes. The aim of this paper is to carry out statistical analysis to seek suitable probability distributions which adequately fit the measured ice load and therefore suitable to be used as parent distributions for long-term estimation. For this aim, three categories of probability distributions, namely standard distributions, truncated distributions and mixture distributions are tested. It is found that truncated distributions can fit the load data better than standard distributions bounded at the threshold. In addition, mixture distributions are shown to have promising features, which fit the data well and are able to separate distribution components. Subsequentially, the well-performed distributions are used as parent distributions to make long-term load estimations. The estimation results demonstrate that long-term estimations are sensitive to the selection of parent distribution, which addresses the importance of finding correct distribution to model short-term ice loads. The data of ten selected cases will be published for the use of other researchers.     

亚帆中心工程环抱形防波堤掩护效果及护面块体稳定性试验研究

针对工程环抱形防波堤平面布置方案,利用整体物理模型试验手段进行了验证。结果表明:1)掩护后传入港内波峰线发生了偏转和波能集中,致使码头局部泊稳条件不满足标准要求。将位轴线顺时针旋转15°,与波峰线平行优化布置后,则满足。2)根据越堤波浪是否冲击港内码头轴线标准,论证10.0、10.5、11.0 m共3个防波提高程掩护体,得出11.0 m是可行的。3)防波堤外侧质量6 t护面块体失稳,经多次优化后采用质量10 t则稳定,弧形转弯处勾连性护面块体受侧向波浪力作用比受正向波浪力偏于危险。4)将试验结果与规范公式计算值进行对比,前者均大,因此对于弧形转弯段的处理应给予关注,尽量遵循规范要求轴线夹角的相关规定。5)试验再次验证了三维港池整体物理模型试验在防波堤稳定性、越浪量和优化设计方面的必要性。     

粉质黏土层大直径泥水盾构掘进地层扰动分析

针对盾构机在粉质黏土层中推进引起的地层扰动进行分析尤为重要。以新建京张高铁JZSG-1标段清华园隧道2号～1号盾构区间为例,采用现场实测与数值模拟相结合的方法,研究大直径泥水平衡盾构隧道穿越粉质黏土层引起的地层扰动,得到土体横向水平位移及地表沉降的变化规律。需对横向1.5D范围内地表及建(构)筑物进行地层加固、加强监控量测;在盾构掘进过程中,应根据沉降数据实时调整盾构掘进参数及加固方案,以期更好地控制地表沉降。针对掌子面释放系数和注浆层软化模量进行参数分析数值计算,提出地表沉降的有效控制方法,在条件允许情况下适当提早管片的拼装及适当加快注浆层的硬化速度,可有效控制地表沉降。     

郑万高铁隧道大型机械化施工支护优化

为解决郑万高铁大断面隧道建造过程中初期支护、二次衬砌、超前支护等支护结构安全储备较大、支护不经济的问题,以郑万高铁湖北段大断面隧道工程为依托,基于通用设计图A开展支护结构应力应变现场测试,对测试数据进行分析,并据此提出支护参数优化方案。采用现场实测和荷载-结构有限元方法对优化方案进行检算,最终确定优化设计图B,并进行现场应用。结果表明： 支护结构整体处于安全状态,优化方案合理可行。该支护优化方案不仅可以有效保证大断面隧道的安全性和稳定性,而且能降低成本,提高材料利用率,减少现场作业人员的劳动量。     

郑万高铁大型机械化施工隧道位移控制基准研究

依托郑万高铁湖北段大断面隧道洞群,针对其开挖断面面积大、软弱围岩占比高、采用大型机械化大断面法施工的特点,开展初期支护位移现场监控量测,对监控量测数据进行分类统计、包络回归分析,得到Ⅳ、Ⅴ级围岩深、浅埋不同大断面法（全断面法、微台阶法）开挖下初期支护位移沿隧道纵向的函数表达式及各工况下分段位移占极限位移的比值。最后结合 Q/CR 9218-2015《铁路隧道监控量测技术规程》中初期支护极限位移值,给出郑万高铁大型机械化施工隧道各工况下初期支护位移控制基准建议值。结果表明： 郑万高铁隧道Ⅳ、Ⅴ级围岩采用深、浅埋不同大断面法开挖时,按距掌子面距离的分阶段位移控制基准相差较大,现行Q/CR 9218-2015《铁路隧道监控量测技术规程》中统一规定不合理;围岩级别、埋深及开挖方法相同时,拱顶沉降和洞周水平收敛规律基本一致。